Wind tunnel Description
New control system and continuous monitoring.
We have a model for each application:
- Cabins and laminar flows modules.
- Biosafety cabinets.
- clean rooms of the pharmaceutical industry, laboratories, operating rooms etc..
Biosafety cabinets and laminar flows
This is a control and electronic monitoring system wirelessly operated via a mobile device which can activate the fan , lights, electrical outlets, etc. and additional monitoring plenum pressure, airspeed, temperature, humidity and other parameters deemed necessary to operate the equipment.
But the most significant advantage is connectivity, This means that the cabin has all the advantages of a mobile device
- A) Telephone communication, whatsapp, mails, etc.
- B) Photography and filming everything that takes place in the cabin.
- C) Skype possibility of a teleconference and have external advice regarding the process to be performed in the cabin.
- D) Remote monitoring option from the desktop PC plant.
- E) Very competitive cost of acquisition over other systems.
- F) No wiring required, just install the module and communication is via WiFi.
Technical characteristics:
Supply voltage: 220 volts AC
Air speed range: 0 a 2 m / seg (configurable) ( 0.2 % FS)
Differential pressure range: -2 a +2 kpa ( +/- 2.5 % FS )
Temp. : -40 a 80 ºC (+/- 0.5 ºC)
Humidity range : 0 a 100 % (+/- 2% FS)
Output relays: until 10 amp
cleanroom:
Pharmaceutical industry, laboratories, operating rooms etc..
It is an electronic monitoring system wirelessly operated through software installed on desktop PC can configure and monitor the differential pressure of the room with adjacent rooms, temperature, humidity, brightness , etc.
Communication modules is via wifi to the nearest modem and then to the network.
The fact that the module possesses wifi communication allows each room also can communicate simultaneously with a mobile devices (cell phone, tablet, etc.).
This is called multimonitoring.
Through the software can be configured differential pressures and alarms, incorporating the floor plan and location of the modules, print reports, graphic , etc.